Easy Installation and Removal

Installing and removing our vinyl skins is a simple and hassle-free process. With the following step-by-step guide, you can apply and remove the skins from your devices with ease:

1. Clean and Prepare: Start by ensuring that the surface of your device is clean and free from any dust, oil, or residue. Use a gentle cleaning solution and a microfiber cloth to wipe down the surface and ensure a smooth application.
2. Align and Position: Carefully align the skin with the contours and openings of your device. Take your time to position it accurately, ensuring that it covers the desired areas while leaving necessary ports and buttons accessible.
3. Heat the Glue (Optional): To enhance the adhesive properties of the vinyl skin during installation, you can use a hairdryer on a low heat setting to warm up the glue slightly. Hold the hairdryer a few inches away from the skin and move it in a circular motion for approximately 10-15 seconds. This step is optional but can help in achieving a stronger bond.
4. Peel and Apply: Once you have determined the correct placement, peel off the backing paper from the skin. Take care not to touch the adhesive side with your fingers. Begin applying the skin slowly, starting from one edge and gradually moving across the surface. Smooth out any air bubbles or wrinkles as you go along.
5. Adjust and Finetune: If needed, gently lift the skin and reposition it to achieve the desired alignment. The adhesive allows for readjustment without leaving any residue on your device. Take your time to ensure a perfect fit.
6. Press and Secure: Once you are satisfied with the placement, firmly press down on the skin, particularly around the edges and corners, to ensure a secure bond. Use a soft cloth or a squeegee to smooth out any remaining air bubbles or creases.
7. Easy Removal: Should you ever wish to change or remove the vinyl skin, it can be done effortlessly and without any damage to your device. Start by heating the skin with a hairdryer on a low heat setting. Hold the hairdryer a few inches away from the skin and move it in a circular motion for approximately 10-15 seconds. The heat will help soften the adhesive and make the removal process easier.
8. Gently Peel Off: After heating the skin, start peeling it off slowly from one edge. Take your time and be gentle to avoid any residue or damage. If any adhesive remains on your device, you can use a mild adhesive remover or rubbing alcohol to clean it off.
9. Brand New Look: Once the vinyl skin is removed, your device will look as if it's brand new. The skin leaves no residue or marks behind, giving your device a fresh and clean appearance.